I can get it to make a straight line, but it says it is also supposed to make curves, and I haven’t figured that bit out yet.
@trin Hey. Hmm well the polyline tool is a bit of a WIP right now. To make it make curves you have to enable the “bezier” option in the toolbox…but that hasn’t been tested thoroughly, and at least for me it has crashed before.
However if you enable that option the software will start to make curved lines whenever the angle between any two given lines is an obtuse angle (that is between 90° and 180°). So basically the criteria it uses to create curves is that everything except almost right (90°) or almost straight (180°)angles will curve the lines. Here’s a GIF that illustrates this behavior.
1 Like